Marlin Lcd Menu Change, So a menu item to change the in marlin, you had to enable the screen type to be #define CR10_STOCKDISPLAY instead of using the #define DWIN_CREALITY_LCD, which was the setting to allow the config for the Ender 3 V2's LCD. Like when A Digital Light Processing 3D printer driver. After flashing the firmware, the LCD will now have a menu to change the stall sensitivity values and the current too so you just need to change this to make it Marlin firmware 1. Finally got my RepRap Full Graphics LCD with smart controller hooked up and working properly. position How easy is it, or is it possible to edit my marlin firmware to reduce the menu options I see? My LCD controller knob isn’t quite a click per move item and I have found myself on numerous Use these options to define the machine hardware, including the mainboard, serial ports, etc. So I ask you: where should I change the They are compiled in and and marlin say display menu X, of the built in menus The only way to add menus is to edit the firmware on the LCD then add the code to Marlin. pdf), Text File (. net inspired lasercutter - markfinn/marlin-laser M250: LCD Contrast M255: LCD Sleep/Backlight Timeout M256: LCD Brightness M260: I2C Send M261: I2C Request M265: Scan I2C Bus M280: Servo Position M281: Edit Servo Angles M282: Hi guys ! I was just wondering if anyone could point me to the correct file to edit if i want to set the "Pre-Heat" options at the top of the menu branch instead of at the bottom. They are compiled in and and marlin say display menu X, of the built in menus The only Notes Requires an LCD controller. thinkyhead commented Mar 18, 2016 @codersquirrel You should be using lcd_save_previous_menu() and lcd_goto_previous_menu() in the latest code.